3.5 Completing a Print

Once the print is completed, the LCD generates a screen similar to the one shown in Figure 3.20.

pict

Figure 3.20: Print From SD Card Complete

This screen shows how long the print took (in hours and minutes) and how much filament was used (in meters). You are also given the options of either reprinting the item or returning to the main menu. If you choose to print another copy, you must first clear the build plate before selecting “Print Another Copy”, as the reprint will then begin immediately. Note that pressing the left key will also return you to the main menu.

If you instead printed over USB, you should see a screen similar to the one in Figure 3.21 below. The only difference is that the option of printing another copy is not available.

pict

Figure 3.21: Print From USB Complete